Maxim-integrated MAX78630+PPM Evaluation Kit Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
MAX78630+PPM Evaluation Kit User Manual
14 Rev 0
3 Serial Interfaces Selection and Configuration
The MAX78630+PPM has integrated UART, SPI (Slave), and I
2
C (Slave) interfaces. Only one interface can be
active at a time and the selection is done at reset/power-on.
The UART interface also supports RS-485/422. The MAX78M6630+PPM EV board includes an isolated RS-
485/422 transceiver.
Table 9 shows the settings of SW4 for the individual interface selection; the signal IFC0 and IFC1 are sampled
at reset and power-on.
Table 9: SW4 Serial Interface Selection
Interface Mode
SW4 1
(IFC0)
SW4 2
(IFC1)
SPI 0 (ON) X (don’t care)
UART 1 (OFF) 0 (ON)
I
2
C 1 ()FF) 1 (OFF)
The MAX78630+PPM EV board provides the serial port signals on connector J16.
3.1 UART Interface Settings
The MAX78M6630+PPM implements a serial communication protocol (SSI) that supports multipoint
communication. The device address (lower bits) is selected through the pins ADDR0 and ADDR1, as shown in
Table 10. The upper bits of the address are set through the register DEVADDR, as described in the IC data
sheet.
Table 10: SW5 Address Selection
Device Address
DEVADDR[5:1]
SW5 2
Bit 1
SW5 1
Bit 0
The EV board includes an isolated RS-485/422 transceiver. The MAX78630+PPM serial UART is connected to
the RS-485/422 transceiver when a multi-drop RS-485/422 bus is available.
UART/USB Interface and UART/RS-485/422 Interface Configuration
In order to operate the UART through the USB/FTDI device or RS-485/422, the jumper must be set according
to
Table 11.
Table 11: Jumper Setting for UART/USB Interface
Jumper
Position
J17 1-2
J18 1-2
J28 Removed
J29 Removed
J27 Removed
J38 Removed
J30 Removed
J12 Removed
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comentarios a estos manuales

Sin comentarios